Chocolate Bundt Cake Recipe (2024)

FAQs

How many cups of batter for bundt pan? ›

How much batter should go into a Bundt pan? Broadly speaking, a classic 10-cup pan should contain enough batter to reach the two-thirds mark, but should be no more than three-quarters full.

The Best Trick For Releasing a Cake From a Bundt Pan

Usually the cake likes to cling to the tube in the middle, so nudging it loose there can be all it takes. After doing this, carefully flip the bundt pan over and lightly shake it.

Allow the Cake to Cool

Once you've cooked your bundt cake and removed it from the oven, allow it to cool in the pan for 10 minutes. Then place a wire cooling rack over the base of the cake and invert the pan to release.

Bundt Cake Pan Capacity

Traditional Bundt cake pans hold 12-cups of batter, which is the perfect two-cake cake mix size. Most recipes that make 10 to 12 cups of batter will fit perfectly in most bundt cake pans.

After removing from the oven, place the pan on a wire rack and let cool; your recipe will specify the required time, usually from 10-20 minutes. This allows the cake to become firm enough to remove from the pan without breaking apart.

To make a box cake mix rise higher, try using a smaller pan, adding an extra egg, using milk instead of water, adding baking powder, mixing for longer, using room temperature ingredients, baking at a higher temperature, or using cake strips.

Rebel bakers who flout the rules should know that using Pam on nonstick bundt pans without ruining them is all about the cleanup. First, after you've sprayed your pan with Pam and poured in your cake batter, take the time to carefully wipe off every bit of the excess Pam on the edges of the bundt pan.

Let the cake rest for 5 minutes once you remove it from the oven. Then, flip the cake onto a cooling rack upside down and let it rest for about 5 minutes before you remove the pan. A little trick here is to use a grid cooling rack, not one that has big gaps.

The idea behind this test is you can insert a toothpick or paring knife into the center of the cake to see if the crumb has set. If the tester comes out clean, it's done.

STEP 3: Pour the prepared batter into the pan, filling it 2/3 to 3/4 full. This will allow room for the cake to rise and prevent overflow.

Why is the bottom of my bundt cake not flat? ›

Sometimes Bundt pans can cause your cake to have a domed bottom, which means the cake won't lay flat. To avoid this, Dalquist says to turn the oven temperature down 25 degrees from what the recipe calls for. "This method needs a little more baking time, but not substantial, and creates an even cake," she explains.

10-inch Bundt pan holds 10-12 cups of batter, the same as a 10×2 inch round pan (10 cups), 9×2 inch square pan (10 cups), 10×2 inch square pan (12 cups), 11×7 inch pan (10 cups), 10×15 inch jelly roll pan (10 cups), 12×17 inch jelly roll pan (12 cups), 9×2.5 inch springform pan (10 cups), 10×2.5 inch springform pan (12 ...

your 9-1/2 inch pan is almost certainly 10 cup capacity. a good rule of thumb is to fill it no more than two-thirds full. but i sometimes fill it as much as 1-1/2 inch from the top and then it domes above the center tube while baking. you will have extra batter using the smaller pan so use it to bake cupcakes.

Batter Capacity

Generally for 1 or 2-inch-deep pans, you will fill them 1/2 full of batter. For pans that are 3 or 4-inch-deep, the batter needs to be about 2/3 high.